Front Suspension Upgrade

[MightyMike]

I finally installed my NOS M1008 front axle assembly onto my truck. Along with this, I will be installing a cross-over/high-steer kit. As far as the steering goes and as mentioned on another post, I'm keeping my manual steering box and adding electric power steering. If the electric power steering doesn't deliver, I'll swap everything out for hydraulic power steering.

IMG_2176.jpg
IMG_2174.jpg
IMG_2209(1).jpg

[Kaiserjeeps]

A great match for the rear you did. Looking forward to seeing more of your build.

[MightyMike]

Thank you! I'm just working a little bit here and there. Today I am running new brake lines.

[eightydeuce]

Looks good. I have a very similar set-up as you and went high steer because the tie-rod was just too close to the spring.

[Bdubya-USAF]

Definitely looking forward to seeing your electric power steering setup. More and more these have kinda caught my eye. Certainly do like the idea of power steering without the fluid.

[MightyMike]

I'm eager to get it setup. At present, I have many installs going in at various states of completion. The electric power steering just needs a power source; however, I still need to finish up the steering down below. I also need to get some Raptor liner and/or sound deadener in the cab, so everything under the dash will be pulled out for that project.