So among a bunch of other things, I worked on the brakes.

I used the W37263 wheel cylinders mentioned in other threads and ground out the "Mickey Mouse Ears" a bit to allow them to fit. For reference, here is a comparison with the W37263 on the left and the original on the right. You can see the difference in the distance between the edge of the ruler and the mounting holes.


The front brakes were cleaned up without much issue. For reference, my shoes were different lengths. The front half of the axle measured about 13 inches, the rear half of the axle about 14.
Front:


Rear:


If you are looking for the rubber plugs for the star wheel adjuster, I found these and they fit well:


I even managed to get the arrow going the right way on the upper block thingy:


The fronts are all set:


As for the rears....