My Build

[randall555]

If you have trouble getting deuce axles on ebay, I will have some at the Findlay ohio meet in May(I think its May). Probably a better price than on ebay too. LMK.

what meet in may ? im in cleveland ohio and would be interested in a swap meet of some type so let me know the details . thanks

[spgirard30]

I got my tires this week, I am going out to the shop this afternoon to go through all the parts and I will take plenty of pictures to post up soon.

[spgirard30]

here are some pictures.





My motor will start going together this week and I hope to have some pictures of that before I have to head back overseas.

I got it out today and drove it around town. It was a little cold wth no top and 39 degrees outside but it was still fun to drive.

[spgirard30]

I picked up my transmission and transfer case this morning. I didnt realize it was a slip yoke 205 but I got a great deal on it so I will either find an SYE kit for it or sell it and buy another 205. Anyone know where to find a good SYE kit.

[spgirard30]

found an SYE kit on advance adapters that will work fine.

[foodstamp]

man this is going to be a sweet build, im gong to keep a eye on this. always wanted to do rockwells on my truck. goodluck!

[ryanroo]

the output and bearing retainer from any fixed yoke 205 will work just fine. if i was closer to the stockpile i have in iowa i could hook you up. i am sure you can find one cheaper than AA.

finding a transfer case that will bolt up in place of that one may be difficult. you have the somewhat rare round pattern 205 if i am seeing it right. the only round pattern ones that came stock with a fixed rear yoke came from the four door trucks with the 2 piece driveline.

if you don't mind me asking, what did you have to ogive for that set up? i am curious because in the process of my build i ended up buying one and shipping from maine.

Ryan

[spgirard30]

I got the combo for 300 and I found it only about 70 miles away on craigs list.

[spgirard30]

here are some of my engine parts. I am going to be right around 9.3 to 1 compression on a SBC 383 stroker. We are building to be right around 450 hp

[spgirard30]

and here is some of the work I did today, the doors had a lot of surface rust on them so I took them off and sanded them down then put back all the hardware for the door latches and window cranks