My Build

[brute4c]

Tight but looks like it will work.

How close is the front of that driveshaft to the tank?

[spgirard30]

looks good. do you still need some doors?

Yes I still want a set of doors. I want to make some half doors.

[spgirard30]

Tight but looks like it will work.

How close is the front of that driveshaft to the tank?

the rockwell is offset to the passenger side so its a few inches from the tank.

[TheDude]

Great build. Subscribed.

RM

[spgirard30]

brakes are bled and the front driveshaft is in. I am having a few issues to figure out. Blinkers aren't working but I have LED's and I think I need an LED flasher for it. When I turn on the headlights on the park lights go out. The brake lights aren't working but I used the old stock pressure switch.

Here is the first time it was put in four wheel drive. I need to weld up the rear gears.

[brute4c]

Park lights do go out with the headlights on...

People have had to do something to get enough resistance in the turn signal circuit to get leds to work...one guy wired in a regular bulb under the dash to each circuit...

[fabricator]

just went back through your whole thread, but didn't hear or see anything on what you used for a master cylinder?

[spgirard30]

I don't remember what master I have. Ijust grabbed one off the shelf that worked.

[spgirard30]

I havent updated in a while so I thought I would do so now. I have been driving the 715 a little here and there. I have a total of about 75 miles it now. I have pulled a large tree trunk out without much of a problem and I plowed through some pretty big snow piles. I wish I would have gotten video, I will be sure to the next time.

[spgirard30]

A little progress for the new stroked bbc.

new heads.


Some krinkle paint on some cheap chrome valve covers.